Operation 5
Commissioning
7311_003-048
1
2
3
Fastening and releasing the seat belt
(variant)
Fastening the seat belt
NOTE
Sit as far back as possible so that your back
is leaning against the seat backrest. The
automatic blocking mechanism permits
sufficient freedom of movement on the seat.
– Pull the seat belt (3) out
of the belt retractor
without jerking and fast
en closely around
the body over the thighs.
– Click the belt tongue (2) into the buckle (1).
– Check the tension of the seat belt. It should
be close to your body.
* Variant
Fasteningonasteeps
lope
The automatic blocking mechanism prevents
the belt from being extended when the truck is
on a steep slope. It is not possible to pull the
seat belt any further out of the belt retractor.
– Move away carefully from the slope.
– Fasten the seat belt
.
Thawing the buckl
e and belt retractor
CAUTION
Danger of material damage from overheating!
Do not subject the buckle or belt retractor to exces-
sive heat when thawing.
– Do not use air warmer than 60°C when thawing.
– Thaw the buckle and the belt retractor.
– Thaw slowly and carefully.
– Dry the parts to prevent them from refreez-
ing.
172
780 EN - 06/2017 67
To Next Page
Loading...
Need help?
General
