2 Introduction
Residual risk
Construction and equipment of the truck
correspond with the Machinery Directive
2006/42/EC and are therefore identified
with the CE symbol. They are therefore not
included in the hazard assessment, and
neither are the attachments on account of their
own CE labelling. The operating company
must, however, select the type and equipment
of the trucks so as to comply with the local
provisions for deployment.
The result must be documented (§ 6 Arb-
SchG). In the case of truck deployment involv-
ing similar hazardous situations, the results
can be summarised. For this overview, see
chapter "Overview of hazards and counter-
measures", which provides help on complying
with this regulation. The overview specifies
the main hazards that are the most frequent
cause of accidents in the event of non-compli-
ance. If other major operational hazards are
involved, they must also be taken into consid-
eration.
The conditions of use for
trucks are broadly
similar in many plants, s
o the hazards can
be summarised in one over
view. Observe
the information provide
d by the relevant
employers' liability in
surance association on
this subject.
Overview of hazards an
d counter-
measures
NOTE
This table is intended to help evaluate the
hazards in your facility and applies to all drive
types. It does not claim to be complete.
NOTE
Observe the national regulations for your
country!
14 1
72780 EN - 06/2017
To Next Page
Loading...
Need help?
General
