5 Operation
Commissioning
7090_342-005
1
4
Releasing the seat belt
– Push the red button (4) on the buckle (1).
– Slowly guide the belt tongue b
ack to the
retractor by hand.
– Using increased force, pull the seat belt
around 10-15 mm out of the retractor to
disengage the blocking mechanism.
– Slowly allow the seat belt to retract again.
– Protect the seat belt from d
irt (for example,
by covering it).
NOTE
Do not allow the seat belt to retract too quickly.
The automatic blocking mechanism may be
triggered if the belt tongue strikes the housing.
It will then no longer be possible to pull the seat
belt out with the usual force.
Checking the manual tow coupling
(variant)
WARNING
Risk of trapping or crushing!
– Do not reach into the open coupling.
NOTE
If the coupling is engaged and disengaged
more than 2-3 times per shift, the coupling
must be relubricated.
– Push the towing pin (2) downwards, turn the
pin by 90° and pull the pin out.
– Check towing pin for damage.
– Clean any debris from the locating hole.
– Insert towing pin, push it downwards
against the pressure of the locking spring,
rotate 90° and lock it in place.
68 1
72780 EN - 06/2017
To Next Page
Loading...
Need help?
General
