Operation 5
Commissioning
Commissioning
Connecting the battery
1
Connecting the battery
CAUTION
Danger of damage to electrical and electronic
components from short circuiting!
Connecting or disconnecting the battery with the
truck switched on may cause damage to electrical
and electronic components.
– Always turn off the key switch.
– Open the battery cover; see chapter entitled
"Opening the battery cover and engine
cover".
– Connect the battery male connector (1) to
the battery connector.
– Close the battery cover.
Switching on the truck with the key
switch
WARNING
Risk of accident as a result of improper commissi-
oning!
Before switching on the key switch, all tests prior
to commissioning must be performed without any
defects being detected.
– Carry out tests before the commissioning, see
the chapter "Checks and tasks to be carried out
prior to commissioning".
– Do not commission the truck if defects have been
identified.
– Contact your service centre.
– Insert the switch key into the key switch (1)
and switch on by turning clockwise.
All indicators on the display of the display
unit light up briefly — the truck is ready for
operation.
172
780 EN - 06/2017 59