6 Maintenance
Servicing
– Raise the truck from the floor until the
wheels are no longer in contact with the
ground.
– Remove the square timbers.
– Remove the hydraulic jack and t
he special
lifting block.
– Lower the truck onto the ground.
– Tighten the wheel bolts crosswise with a
torque of 195 Nm.
– In the interest of safety, t
he correct assem-
bly of the wheel bolts MUST b
e checked
after 50 hours of operation
.
NOTE
If the wheel bolts need retightening to the
correct torque, they must then be checked
again after 50 hours. Repeat this procedure
every 50 hours until the correct torque is
consistently obtained.
188
172780 EN - 06/2017
To Next Page
Loading...
Need help?
General
