Checking the brake system for cor-
rect function
DANGER
If the brake system fails, the truck is insufficiently
braked or not braked at all, so there is a risk of ac-
cident!
– Do not commission trucks with a defective brake
system.
Checking the foot brake
– Release the parking brake.
– Depress the brake pedal (1).
There must be a slight pedal clearance and
then a noticeable brake pressure point.
– Accelerate the unladen truck in a clear
area.
– Press the brake pedal firmly.
The truck must decelerate noticeably.
Checking the parking brake
DANGER
If the truck rolls away, there is a risk of being run
over and therefore a danger to life!
– The truck must not be parked on a slope.
– In emergencies, secure with wedges on the side
facing downhill.
– Only leave the truck when the parking brake is ap-
plied.
– Actuate the parking brake at walking speed
or on a steep gradient.
The truck must stop and remain stationary.
– If the truck continues to roll despite the
parking brake being applied, notify the au-
thorised service centre.
1
5060_003-015
6210_342-005
Operation
4
Checks and tasks before daily use
100 57348011850 EN - 08/2020 - 12
To Next Page
