Decal information with the following data must
be permanently affixed to the truck so that it is
clearly visible:
●
Type of modification
●
Date of modification
●
Name and address of the company that car-
ried out the modification
Changes to the overhead guard and
roof loads
DANGER
In the event of the overhead guard failing due to a
falling load or the truck tipping over, there are po-
tentially fatal consequences for the driver. There is
a risk to life!
Welding and drilling on the overhead guard changes
the material characteristics and the structural design
of the overhead guard. Excessive forces caused by
falling loads or the truck tipping over may result in
buckling of the modified overhead guard and no pro-
tection for the driver.
– Do not perform welding on the overhead guard.
– Do not perform drilling on the overhead guard.
CAUTION
Heavy roof loads damage the overhead guard!
To ensure the stability of the overhead guard at all
times, a roof load may only be mounted on the over-
head guard if the structural design has been tested
and the manufacturer has given approval.
– Seek advice from the authorised service centre for
the mounting of roof loads.
Warning about any manipulation of
the internal combustion engine
The internal combustion engine used in this
truck possesses an EU type approval, which is
required for the legitimate operation of this
truck.
Manipulation of the internal combustion en-
gine in any way invalidates this EU type ap-
proval. In this case, operation of the truck is
also no longer permitted.
Safety
2
Basic principles for safe operation
2557348011850 EN - 08/2020 - 12
To Next Page
Loading...
