– The belt tongue (2) must release when the
red button (4) is pressed.
– The automatic blocking mechanism must be
tested at least once a year:
– Park the forklift truck on level ground.
– Pull out the belt with a jerk.
The automatic blocking mechanism must
block extension of the belt.
– Tilt the seat at least 30 ° (if necessary, re-
move the seat).
– Slowly extend the belt.
The automatic blocking mechanism must
block extension of the belt.
Cleaning the seat belt
– Clean the seat belt as necessary, but with-
out using chemical cleaning materials (a
brush will suffice).
Replacement after an accident
As a rule, the seat belt must be changed after
an accident.
Checking the driver's seat
WARNING
Risk of injury!
– After an accident, check the driver's seat with at-
tached restraining belt and fastening.
– Check the controls for correct operation.
– Check the condition of the seat (e.g. wear
on the upholstery) and secure fastening to
the hood.
WARNING
Risk of injury!
– Have the seat repaired by the service centre if you
identify any damage during the checks.
7090_342-005
1
4
6327_342-010
Maintenance
5
Preserving operational readiness
33557348011850 EN - 08/2020 - 12
To Next Page
