fixed elements of the surrounding area. The
height is based on the overall height of the lift
mast and the dimensions of the load. Observe
the technical data (see
⇒
Chapter "Technical
data", Page 351 ).
Rules for roadways and the working
area
It is only permitted to drive on routes author-
ised for traffic by the operating company (see
⇒
Chapter "Definition of terms used for respon-
sible persons", Page 20 ) or its representa-
tives. Traffic routes must be free of obstacles.
The load must only be set down and stored in
the designated locations. The operating com-
pany and its representatives must ensure that
unauthorised third parties keep away from the
working area.
Hazard areas
Hazardous areas on the roadways must be
marked by standard traffic signs or, if neces-
sary, by additional warning signs.
Setting the drive programmes
The driving and braking characteristics of the
drive can be set on the display and operating
unit.
– Push the drive programme button (1) re-
peatedly until the number of the desired
drive programme appears on the display
(2).
Drive programs 1–5 are available.
Essentially, the higher the drive program num-
ber is, the greater the driving dynamics.
NOTE
On some trucks, the speed (forwards/back-
wards) is restricted as a variant.
The following settings are possible:
7312_003-167_V3
1
1
2
Operation
4
Driving
124 57348011850 EN - 08/2020 - 12
To Next Page
Loading...
