Emergency lowering
If the hydraulic controller fails whilst a load is
raised, emergency lowering can be performed.
An emergency lowering screw is located on
the hydraulics control block for this purpose.
DANGER
There is a risk of fatal injury from falling
loads or parts of the truck being low-
ered.
– Do not walk beneath the raised load.
– Adhere to the steps detailed below.
WARNING
The load is lowered!
The lowering speed is regulated by unscrewing the
emergency lowering screw.
– Note the list of points below.
Remember the following:
●
Tightening torque:
Max. 2.5 Nm
●
When unscrewed a little:
The load lowers slowly
●
When unscrewed a lot:
The load lowers quickly
Operation
4
Procedure in emergencies
282 57348011850 EN - 08/2020 - 12
To Next Page
