CAUTION
Components may become damaged through incor-
rect use!
Truck components, such as the driver's seat, steer-
ing wheel, parking brake lever etc., are not designed
to be used for climbing in and out of the truck and
may be damaged due to misuse.
– Only use the fittings specifically designed for the
purpose of climbing into and out of the truck.
If the truck is equipped with a raised driver's
cab, the driver's compartment is significantly
higher than that of a standard truck.
For this reason, particular care must be taken
when climbing into and out of the truck. The
following section describes the best procedure
to adopt.
NOTE
The foot that the driver starts with when climb-
ing into and out of the truck is crucial in ensur-
ing this action is carried out safely. This will
depend on the number of steps.
To assist when climbing into and out of the
truck, use the handles (2) and (4) for support.
The post of the overhead guard (1) can also
be used for support.
Always
climb into
the truck facing forwards.
– Grip the handle (2) with your left hand and
do not let go.
– Grip the handle (4) with your right hand and
do not let go.
– Place your right foot on the bottom step (5).
– Place your left foot on the top step (6).
– Place your right foot into the foot well (7).
– Enter the truck and sit down on the driver's
seat (3).
Always
climb out of
the truck backwards.
– Grip the handle (2) with your left hand and
do not let go.
– Stand up from the driver's seat and place
your left foot on the top step (6).
Operation
4
Checks and tasks before daily use
7157348011850 EN - 08/2020 - 12
To Next Page
Loading...
