Storz AIDA C WD310 - Page 34

Installation and commissioning
Instructions for use • AIDA C WD310 • AAB272_EN_V2.0_12-2021_IFU_CE-MDR 34
Setting up the watermark
1. Place a check mark next to
Enable Watermark Logo
.
2. Tap the "
...
" button.
3. Select the logo in the file directory and confirm with
Open
.
The place where the watermark logo is stored must be on the local hard disk. If necessary, a
relevant archive must be created by a service technician.
4. Adjust the size of the watermark under
Watermark Logo Scaling
using the
Plus
and
Minus
buttons.
5. Set the transparency of the logo under
Watermark Transparency Amount
using the
Plus
and
Minus
buttons.
ð The watermark created is displayed in the preview window.