strapex SMA 20 - Change Strap Coil

26
02.11
Strapex SMA 20
Fig. 6
1 Table top
2 Handle nut
3 Front disc
4 Strap coil
5 Transportation band
6.5 CHANGE STRAP COIL
See also diagram for threading the strap
into the inside of the machine frame.
– Open table top (6/1). When the table top is open the
power circuit of the motor is interrupted.
Do not touch hot heating element!
– Remove handle nut (6/2) in clockwise direction (left-
handed thread).
– Take off front disc (6/3) and remove remaining
strap.
– Insert new strap coil (6/4), strap header in direction
of arrow.
– Mount front disc (6/3).
– Mount handle nut (6/2).
– Cut transportation bands (6/5) and remove.
Fig. 7
1 Strap guide
2 Guide pulley
3 Unrolling brake lever
– Lead strap over the unrolling brake lever (7/3) and
under the guide pulley (7/2).
– Push the strap into the strap guide (7/1) by hand
until resistance is felt.
– Close table top (6/1).
– Turn Main switch to position „1“.
– Toggle switch (3/6) on.
– Activate push-button „Manual strap feed“ (3/10),
until the strap has reached the required length.
1
2
3
4
5
1
2
3