Stratasys Objet350 - Configuring User Alerts

Objet350 User Guide 5 Using Objet Studio
DOC-17001 Rev.G 5-92
Configuring
User Alerts
ObjetStudiocanalertyou(andothers)tothestatusofjobssenttotheserver
forprinting.Thisisespeciallyusefulduringlongprintingjobs,whenthe
operatorisawayfromtheprinter.Thefollowingeventscanbereported:
•Thelevelofmodelorsupportmaterialislow.
•Thejobwasinterrupted.
•Thejobwascompletedsuccessfully.
Tosende-mailandSMSalerts,makesurethate-mailsoftwaresupporting
MAPIisinstalledontheservercomputer.TosendSMSalerts,thecellular
phoneservicemustsupportthetransmissionofe-mailmessagesbySMS.
Onlythesubjectlineofthee-mailmessageistransmittedbySMS.
ToconfigureObjetStudiotosendnotificationsandalerts:
1. OntheJob Managerribbon,inthe3D Printergroup,click .
Figure5-116Notificationsdialogbox(server)