Stratasys Objet350 - Replacing the Odor Filter

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-70
Figure6-105Levelstabilization
5. Selectthecheckbox,andclickNext.
6. ClickDoneinthefinalwizardscreen.
Figure6-106Finalwizardscreen
Replacing the
Odor Filter
Iftheprinterexhaustisnotconnectedtoanexternalventilationsystem,a
built-inactivated-carbonfilterremovesodorsfromprintingmaterials.This
filtershouldbereplacedregularly(asnecessary)tokeepyourworking
environmentpleasant.