Stratasys Objet350 - Printing Indicators

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-9
Printing
Indicators
Theprinterinterfacescreenchangeswhenyousendaprintjobtotheprinter
(fromObjetStudio),iftheprinterison line:
•ThemodechangesfromPre-printtoPrinting.
•Thespecificactivitybeingperformedisshowninthe“currentactivity”
field.
•Currentjob-printinginformationisdisplayed.
•Theprintingprogressbarisdisplayed.
•TheStopandPausebuttonsareenabled.
Whentheweightofacartridgedropsbelow100grams,thedisplayofthe
materiallevelintheprinterinterfaceisred.
Figure6-5Printerinterfaceduringprinting