Stratasys Objet350 - UV Lamp Check 6

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-76
ThewizardoperatestheUVlampsandchecksiftheirpoweriswithinthe
acceptablerangeforeachprintingmode.
Note: Themodecurrentlybeingcheckedappearsinthelower-leftcornerof
theprinterinterface.
Figure6-117StatusscreenduringUVlampcheck
AfterreplacingaUVlamp,itisrecommendedthatyoucalibrateitspower
forthevariousprintingmodes.Thenextscreenallowsyoutocontinueto
theUVCalibrationwizard(see"TestingandCalibratingtheUVLamps"on
page6-61).
Figure6-118Wizardcontinuationscreen