Stratasys Objet350 - Starting the Printer

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-3
Figure6-1TheObjet3503DPrinter
Starting the Printer
Caution
l DonotattempttooperatetheprinterbeforebeingtrainedbyaStratasys
CustomerSupportrepresentative.
l Observeallsafetywarningsandfollowthesafetyguidelinesdescribedin
Chapter2.
1. Turnonthemainpowerswitch,locatedatthebackoftheprinter.
Figure6-2Mainpowerswitchandcable