Stratasys Objet350 - Page 135

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-4
2. Aftertheprinter-controlcomputerboots,logintoWindowsandlaunch
theprinter-controlprogram:
❒ Ontheprinter-computerdesktop,double-clicktheObjet350printer
icon.
or—
❒ FromtheStartmenu,select(All)Programs>Objet>Objet350.
AHASPplugcontainingavalidproductactivationkeyisrequiredonthe
printercomputer.Thisisinstalledatthefactoryorduringprinterupgrade.
IftheapplicationdoesnotopenandaHASPmessageappears,contact
yourdealerorStratasysCustomerSupport.
Allmonitoringandcontrollingoftheprinterisdonefromthisinterface.
Figure6-3Objet350interface
Objet350installationsuseonemonitorfordisplayingboththecomputer
runningObjetStudioandthecomputerinstalledinsidetheprinter.Make
surethattheKVM(keyboard-video-mouse)switchisinthecorrect
positionsothattheprinterinterfaceisdisplayed.