Stratasys Objet350 - Symbols and Warning Labels

Objet350 User Guide 2 Safety
DOC-17001 Rev.G 2-3
Grounded Chassis Thechassisoftheprinterisgrounded,topreventelectrical
shock.
Note:Thepoweroutletmustbeproperlygrounded,in
accordancewiththelocalelectriccode,toprovidethis
protection.
IftheObjet3503Dprintingsystemisnotusedasspecifiedinthisguide,
thesafetyfeaturesmaynotprovideadequateprotection.
Symbols and Warning Labels
ThisfollowingtableliststhewarninglabelslocatedonorinObjet350
printers.
Warning Symbol Meaning Location Comments
Hazard(general) Onthenameplateonthe
backoftheprinter.
Readtheinstructionsin
thisdocumentbefore
operatingtheprinter.
Hotsurface Ontheprintblock. Riskofburns.Donot
touchthissurfaceafter
printing.
Highvoltage NeartheUVlamp
connectors.
Nearthepower-supply
enclosures.
Riskofelectricshock.
Ultraviolet
radiation
NeartheUVlamps. Riskofinjuryfrom
ultravioletradiation.
Movingparts Onthepanelthatis
visiblewhenyouopen
thefrontdoorsofthe
printer.
Riskofinjuryfrommoving
parts.