Stratasys Objet350 - Page 142

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-11
5. If,foranyreason,thecorrectnumberdoesnotappearinthedialogbox,
enterthenumberandclickOK.
Youcannotcontinueprintingthemodelif:
•Thenumberofthelastsliceprinteddoesnotappearintheprinter
interface,eveniftheservercomputerdisplaystheContinue from Slice
confirmationdialogbox.
•Therewasarelativelylonginterruptioninprinting,evenifthe“lastslice”
and“continuefromslice”indicatorsarecorrect.Thepartofthemodel
alreadyprintedmaydeformorshrink,andtheremightbeavisible
differencebetweenitandthenewlyprintedpart.Theeffectsofaprinting
stoppageonamodeldependonthemodelsizeandstructure,Model
materialused,ambienttemperatureandthelengthofthestoppage.
Ifyoucannotcontinueprinting:
1. CanceltheprintjobintheJob Managerscreen.
2. Removethepartiallyprintedmodelfromthebuildtray.
3. RestartthejobfromtheJob Managerscreen(inObjetStudio).
Youcanstopandlaterresumeprintingfromeithertheprinterinterfaceor
fromtheJob ManagerscreenofObjetStudio.AfterclickingtheStop
buttonontheprinterinterface,youcanresumeprintingonlyfromtheJob
Managerscreen.However,afterclickingthePausebuttonintheprinter
interface,youcanonlyresumeprintingfromtheprinterinterface.