Stratasys Objet350 - Page 195

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-64
Figure6-92LabelonthebottomoftheUVsensorbox
ThebuildtraylowerssoyoucanconnecttheUVsensorbox.
Figure6-93UVsensorconnector
2. ConnecttheUVsensorcabletotheconnectorintheprinter.
3. PositiontheUVsensorinthecenterofthetray.
Figure6-94UVsensorinthecenterofthetray
Toensurethatthesensorcabledoesnotinterferewiththebuildtraywhen
itisraised,routeitinbackofthesensor.