Stratasys Objet350 - Page 209

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-78
Accessing
Built-inTests
ToopentheBuilt-inTestsscreen,dooneofthefollowing:
•FromtheOptionsmenu,selectBuilt-InTests.
•PressCtrl+Alt+B.
Figure6-119SelectingBuilt-In TestsfromtheOptionsmenu
TheBuilt In Testsscreenlistspre-configuredtests,groupedbycomponent
categories.Inthisscreen,youselectandruntests,andtheresultsare
displayed.
Figure6-120Built In Testsscreen