Stratasys Objet350 - Page 216

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-85
Thewastecontainerconsistsofaplasticcontainerinsideacardboardbox.
Youtypicallydisposeoftheentirewastecontainer—includingthebox.
Therefore,youmustassembleanewboxandinsertanewplasticcontainer
beforeyoucaninstallitintheprinter.
Replacementboxes,plasticcontainers,andsealingcapsaresuppliedin
theObjet350printerstart-upkitandinthepreventive-maintenancekit.
Toprepareanewwastecontainer:
1. Assemblethecardboardbox,makingsuretopunchouttheperforated
sections.
2. Placeanewplasticcontainerintothebox.
Note: Donotclosetheboxuntilyouconnectthewastedraintubefromthe
printer.
Toreplacethewastecontainer:
1. Locatethedooronthelower-leftsideoftheprinter.
2. Pushinthetop-centerofthedoortoreleasethelatchandopenthedoor.
Figure6-122Accessingthewastecontainer
3. Carefullyslideoutthewastecontainertoremoveitfromtheprinter.
4. Closethefullcontainerwiththecapsuppliedwiththenewwaste
container.
5. Closethenewwaste-containerbox,usingtapetoholditclosed.
❒ Thecontainershouldbeontheextremerightsideofthe
compartment.
❒ Makesurethatthewastedraintubeisnotcrimpedandthatitisnot
pinchedbythecontainer.