Commissioning
124
Verti-Mix SF / Verti-Mix Double SF Version 06.12
6.5 Diesel engine operation
6.5.1 Operation monitoring
This chapter provides a description of the various warning and control
messages which may appear in the terminal to monitor the diesel
engine operation. The warning and control messages displayed
indicate certain functions or malfunctions.
CAUTION
Risk of engine damage due to non-observance of warning
messages lighting up!
In case of a malfunction, the respective warning message appears.
Flashing or lighting symbols indicate danger.
Stop and turn the diesel engine off.
Check the malfunction and remedy the defect.
Contact an authorized workshop if necessary.
6.5.1.1 Warning and control messages for diesel engine operating states
The control message "Sufficient fuel quantity" appears if the fuel
quantity is above the emergency fuel quantity sensor.
Lights up green at large fuel quantity.
Irrespective of the operating mode, touching the symbol initiates the
analog display of the fuel quantity.
The warning message "Fuel quantity too small" appears if the fuel
quantity is below the emergency fuel quantity sensor.
Lights up red at small fuel quantity. An acoustic warning signal
sounds.
Refuel at the earliest possible opportunity.
Irrespective of the operating mode, touching the symbol initiates the
analog display of the fuel quantity.
If the warning message "Diesel engine WARNING" appears, there is
a malfunction in the engine control (e. g. a defective sensor) or a
defective operating state has occurred, e.g.:
engine oil pressure too low,
coolant temperature too high,
coolant level too low,
water in diesel fuel / clogged diesel fuel filter,
air filter soiled,
generator / battery is not charging.
Locate and eliminate as soon as possible the cause(s) for the
appearance of this warning message. Have the diesel engine
checked by an authorized workshop if necessary.
To Next Page
