Safety instructions
Verti-Mix SF / Verti-Mix Double SF Version 06.12
35
3.4.2 Hydraulic system
The hydraulic system is under high pressure!
Only an authorized workshop is allowed to carry out work on the
hydraulic system (shop work)!
Before carrying out any work on the hydraulic system:
secure lifted moving machine parts / the lifted cutter arm
against accidental lowering,
depressurize the hydraulic system,
turn the machine engine off,
apply the parking brake,
pull the ignition key out!
Ensure that the hydraulic hoses and pipes never bend or chafe!
Replace hydraulic hose pipes in case of visible defects, damage
and ageing! Only use original hydraulic hose pipes!
Have hydraulic hose pipes checked for their operational safety
by an expert at least once a year!
The period of use of the hydraulic hose pipes should not exceed
six years, including a maximum possible shelf life of two years!
Even when properly stored and exposed to admissible stress,
hoses and hose connections are subject to natural ageing, which
involves a limited shelf life and period of use. Notwithstanding
these facts, the period of use may be specified according to
experience, in particular taking into account the risk potential.
For thermoplastic hoses and hose pipes, other reference values
may be relevant.
Never try to block leaking hydraulic hose pipes with your hand or
fingers!
Hydraulic oil squirting out under high pressure may enter the
skin and the body and cause serious injuries.
If injuries caused by hydraulic oil occur, immediately contact the
medical services. Risk of infection!
Never try to detect leakage points with your bare hands. Risk of
serious infection! Use appropriate means when trying to locate
leakage points (cleaning sprays, special leak detector spray)!
To Next Page
Loading...
