Safety instructions
34
Verti-Mix SF / Verti-Mix Double SF Version 06.12
Observe the maximum load of the machine and the admissible
axle and tongue loads of the machine! Run the machine being
only partly filled if necessary.
People are not allowed:
within the operating / hazardous area of the machine,
within the discharge area of the machine,
within the turning and swivelling range of movable machine
parts,
beneath lifted and unsecured movable machine parts!
Powered (e. g. hydraulically) movable machine parts have
crushing and shearing zones!
You are only allowed to operate powered machine parts if there
are no people within the machine’s hazardous area!
Secure the machine against accidental starting and rolling before
leaving the driver seat!
Safely support folded-up covers before standing underneath
them!
Transport of machine
Observe the respective national road traffic regulations when
carrying out transport journeys on public roads!
Before carrying out transport journeys, check:
the lighting system for damage, proper functioning and
cleanliness,
the brake and hydraulic system for visible defects,
whether the parking brake has been completely released,
the brake system for proper functioning!
Avoid sudden changes of direction, in particular when travelling
uphill and downhill and when traversing hills!
Set all moving machine parts to transport position before
carrying out transport journeys!
Secure all moving machine parts in transport position before
carrying out transport journeys. Use the transport locks provided for
this purpose!
Before transport journeys, check whether the required transport
equipment, such as lighting, warning and protective devices, has
been properly mounted on the machine!
Adapt your travelling speed to the conditions prevailing at the
time!
To Next Page
Loading...
