Strautmann Verti-Mix SF - Service and Maintenance of Machine

Safety instructions
40
Verti-Mix SF / Verti-Mix Double SF Version 06.12
3.4.8 Service and maintenance of machine
 Carry out the required service and maintenance work on the
machine in due time!
 Secure the machine against accidental starting and rolling before
carrying out any service or maintenance work on the machine!
 Existing mechanical, hydraulic, pneumatic and electrical or
electronic residual energies may cause accidental machine
movements!
Beware of existing residual energies in the machine when
carrying out maintenance work. Warning signs mark the
components with residual energies. For detailed information,
refer to the respective chapters of these operating instructions.
 Keep sufficient safe distance to hot surfaces / components.
 Secure all operating media such as compressed air and
hydraulic oil against accidental startup!
 Fix larger assemblies carefully to lifting equipment and secure
them before replacing larger assemblies!
 Regularly check screws and nuts for tightness! Retighten
loosened screws and nuts!
 Secure the lifted machine or lifted machine parts against
accidental lowering before carrying out service or maintenance
work on the machine!
 Use appropriate equipment and gloves when replacing working
tools with blades!
 Check unscrewed joints for tightness. After finishing
maintenance work, check the safety and protective devices for
proper functioning!
 Dispose of oils, greases and filters properly!
 Properly handle and dispose of substances and materials used
for cleaning the machine, especially:
 when working on lubrication systems and devices,
 when carrying out cleaning work with solvents!
 Disconnect the generator and battery cable and unplug the
computers, before carrying out electrical welding work on the
machine!
 Spare parts must at least comply with the specified technical
standards of the manufacturer! This is guaranteed when using
original parts!
 Observe the maintenance intervals for wearing parts!