Stryker 3002 - Electromagnetic Emissions Compliance

www.stryker.com 3006 -109-101 REV A 73
Return To Table of Contents
Guidance and Manufacturer’s declaration - Electromagnetic Emissions
The S3™ MedSurg Bed, Model 3002 Patriot™ Series is intended for use in an electromagnetic environment
specified below. The customer or the user of the S3™ MedSurg Bed, Model 3002 Patriot™ Series should
assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment
RF Emissions
CI S P R 11
Group 1,
without iBed
®
Wireless option
Group 2,
with iBed
®
Wireless option
The S3™ MedSurg Bed, Model 3002 uses RF energy
only for its internal function. Therefore, its RF emissions
are very low and are not likely to cause any interference
in nearby electronic equipment.
RF Emissions
CI S P R 11
Class A
The S3™ MedSurg Bed, Model 3002 is suitable for use in
all establishments other than domestic and those directly
connected to the public low voltage power supply network
that supplies buildings used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
Complies
S3™ MEDSURG BED, MODEL 3002 PATRIOT™ SERIES (CONTINUED)
EMC Information