ME(H4SO)-59
MECHANICAL
Camshaft
16) Remove the plug from rear side of camshaft.
CAUTION:
• Do not remove the oil seal unless necessary.
• Do not scratch the journal surface when re-
moving oil seal.
B: INSTALLATION
1) Apply a coat of engine oil to the camshaft jour-
nals, and then install the camshaft.
2) Install the camshaft cap.
(1) Apply liquid gasket on the around of cam-
shaft cap.
Liquid gasket:
THREE BOND 1280B
Part No. K0877YA018
NOTE:
Apply a coat of 3 mm (0.12 in) dia. (A) liquid gasket
along edge (B) of the camshaft cap (C) mating sur-
face.
(2) Temporarily tighten the bolts (g) through (j)
in alphabetical sequence.
(3) Install the valve rocker assembly.
(4) Tighten the bolts (a) through (h) in alphabet-
ical sequence.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(5) Tighten the TORX
bolts (i) through (n) in
alphabetical sequence using ST.
ST 499497000 TORX
PLUS
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
(6) Tighten the bolts (o) through (v) in alphabet-
ical sequence.
ME-00264
ME-00265
(A)
(B)
(C)
ME-00266
(g)
(h)
(j)
(i)
ME-00267
ME-00268
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
ME-00269
(i)
(j)
(m)
(n)
(k)
(l)
To Next Page
Loading...
