ME(H4SO)-78
MECHANICAL
Cylinder Block
17) Install the water pipe.
18) Install the baffle plate.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
19) Install the oil strainer and O-ring.
Tightening torque:
10 N·m (1.0 kgf-m, 7 ft-lb)
20) Install the oil strainer stay.
21) Apply fluid packing to the matching surfaces,
and then install the oil pan.
Fluid packing:
Part No. 004403007
THREE BOND 1215 or equivalent
22) Apply fluid packing to the matching surfaces,
and then install the oil separator cover.
Fluid packing:
Part No. 004403007
THREE BOND 1215 or equivalent
23) Install the flywheel or drive plate.
To lock the crankshaft, use ST.
ST 498497100 CRANKSHAFT STOPPER
Tightening torque:
72 N·m (7.3 kgf-m, 52.8 ft-lb)
• MT MODEL
• AT MODEL
NOTE:
Using STs, remove the flywheel. (2.5 L MT model)
ST1 498497100 CRANKSHAFT STOPPER
ST2 499057000 TORX
PLUS
24) Install the housing cover.
25) Installation of oil pump
(1) Discard the front oil seal after removal. Re-
place with a new one using the ST.
ME-00300
ME-00162
ME-00163
(A) Flywheel
NE-00297
ST
ME-00298
(A)
ME-00382
ST1
ST2
To Next Page
