EN(H4SO)(diag)-249
ENGINE (DIAGNOSTICS)
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step Check Yes No
1 CHECK OPERATION OF STARTER MOTOR.
Place the inhibitor switch in the “P” or “N”
range. (AT model)
Depress the clutch pedal. (MT model)
Does the starter motor operate
when ignition switch is turned
to “ST”?
Repair harness
and connector.
N
TE:
In this case, repair
the following:
• Open or ground
short circuit in har-
ness between
ECM and starter
motor connector.
• Poor contact in
ECM connector.
Check starter
motor circuit. <Ref.
to
EN(H4SO)(diag)-
60, STARTER
MOTOR CIR-
CUIT, Diagnostics
for Engine Start-
ing Failure.>