FU(H4SOw/oOBD)-35
FUEL INJECTION (FUEL SYSTEMS)
Idle Air Control Solenoid Valve
10.Idle Air Control Solenoid
Valve
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector from idle air control
solenoid valve.
3) Remove the idle air control solenoid valve from
throttle body.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• Always use a new gasket.
• For tightening torque, refer to “COMPONENT”.
<Ref. to FU(H4SOw/oOBD)-3, COMPONENT,
General Description.>
FU-00009
FU-00937
FU-00938
To Next Page
