Sulzer ABS PC 441 - Page 19

81307063I
EN
15
Overow (optional parameter)
Overowcanbedetectedbyanoverowdetector(MD137)orbythecertainlevel.Seemoreinformationabout
overowin section 3.3.
Backup running (optional parameter)
BackuprunningstartwhenaHigh-level oatgetsactivated.Youcanspecifywhichpumpsshallparticipatein
backuprun,andhowlongthepumpshallrun.
Pit alarms (some parameters are recommended)
There are several alarms which can be set under Pit alarms.EachalarmiscongurabletobeA-orB-alarms.
Consultyourdrawingsandverifywhichareimportantforyourinstallation.
Pump blocking (optional parameter)
Thepumpcanbeblockedonremote.Thereisatimeoutwhichreleasestheblockingafteracertaintime.
BlockingonLow level oat and/or High pressure can be set here.
Level sensor check (optional parameter)
Level sensor checkItispossibletocheckthelevelsensorreadingcomparedtotheinstalledoats.Seethe
settings under Level sensorchecksetthisup.
Tari󰀨 control (optional parameter)
Thisfunctionistoreduceenergyconsumptioninhoursofhighcostofenergy.Youcansetthisupforseparate
daysintheweek.
Level above sea (optional parameter)
Ifyoutypeinavaluehere,thisvaluewillbeaddedinthepitlevelbutnota󰀨ectthestart/stoplevels.
In AquaProg:
Figure 2-4 Pump pit settings