Sulzer ABS PC 441 - Settings for Pulse Channels; Settings for Trend Curves

81307063I
EN
71
5.16 Settings for pulse channels
Table5-14showsthecompletelistofsettingsyoucanmakeunderthesubmenuPulse Channels.
Table 5-14 Settings for pulse channel s,under‘Settings>PulseChannels’
Submenu Submenu Submenu Setting Value Passcode Comment
Pulse Chan-
nel 1
to
Pulse
Channel 4
Function
Precipitation
1 Pulse mm,inch
System
The menus adapt to the choice
youmadeforthefunctionof
Channel 1 and Channel 2.
Alarm High Precip.
(Inactive,B-
Alarm,A-Alarm)
AlarmDelay Seconds
Limit l/s/ha,inch/h
Hysteresis l/s/ha,inch/h
Energy
1 Pulse kWh
Alarm High Power
(Inactive,B-
Alarm,A-Alarm)
AlarmDelay Seconds
Limit kW
Hysteresis kW
Flow
1 Pulse m
3
,gal
Alarm High Power
(Inactive,B-
Alarm,A-Alarm)
AlarmDelay Seconds
Limit m
3
/h,GPM
Hysteresis m
3
/h,GPM
Alarm Low Flow
(Inactive,B-
Alarm,A-Alarm)
OnlyavailableforChannel1and
Channel 2.
AlarmDelay Seconds
Limit m
3
/h,GPM
Hysteresis m
3
/h,GPM
5.17 Settings for trend curves
Table5-15showsthecompletelistofsettingsyoucanmakeunderthesubmenuTrend Curves.
Table 5-15 Settings for trend curves ,under‘Settings>TrendCurves’
Submenu Submenu Setting Value Passcode Comment
- Sample Time Seconds System
Trend Curve 1
to
Trend Curve 4
Signal
(Closed,
PitLevel,
PitInow,
PitOutow,
OverowLevel,
OverowFlow,
Back-Pressure,
MotorCurrent,
PumpCapacity,
PowerFactor,
Temp.Stator,
Temp.UpperBearing,
Temp.LowerBearing,
Vibrations,
MainVoltage,
MainFrequency,
FreeChoice,
SupplyVoltage)
System
Atotalof4trendcurvesyoucan
choose from the list.
MaxValue Number Themaximumandminimum
values are used to set the scales
of the graphs.
Min Value Number