Sulzer ABS PC 441 - Settings for Digital Outputs

81307063I
EN
68
5.13 Settings for digital outputs
Table5-11showsthecompletelistofsettingsyoucanmakeunderthesubmenuDigital Outputs. The default
congurationforDO1-8islistedintheInstallationGuide.
Table 5-11 Settings for d igitaloutputs,under‘Settings>DigitalOutputs’
Submenu Submenu Setting Sub Setting Value Passcode Comment
DigitalOutput1
to
DigitalOutput8
Output Function
(O FF,
Pumpcontrol,
Resetmotorprot.,
Pumpfail,
Toomanypumps
blocked,
Onepumpfail,
Masterresetm.prot.,
Mixercontrol,
Resetm.prot.mixer,
Drainpumpcontrol,
Res.m.protdrain,
Cleanercontrol,
Modemcontrol,
Remotecontrol,
Personalalarm,
Highlevel,
Alarmalert,
Notackn.A-alarm,
Notackn.A/B-alarm,
ActiveA-alarm,
ActiveA/B-alarm,
Pumpreversing,
ActiveB-alarm,
Externalresetalert
System
LogicIO,IO1–IO4
(O FF,
TrueOR,
InverseOR,
TrueAND,
InverseAND)
See Section 4.1
Datareg.setpoint)
DataRegister 0-4529
See Section 4.2
SetpointON Integer
Setpoint OFF Integer
Setpoint
Delay
Seconds
NormallyState
(NormallyOpen(NO),
NormallyClosed(NC))