Sulzer ABS PC 441 - 5 Settings; Select Language; Overview of Settings

81307063I
EN
51
5 SETTINGS
5.1 Select language
1. Choose the menu item Select language and press Enter twice.
2. Enter the pass code Operator (default is 2). Press Enter.
3. ScrolltothelanguageofyourchoicebyusingtheUp/down buttons.
4. Press Enter and then the Left/backward arrow.
5.2 Overview of settings
The menu item Settingshas21submenuswithalargenumberofsettingsthatneedtobeenteredbythesys-
temadministrator,althoughtheyallhavesensibledefaultvalues.Thefollowingarethe21submenus:
5.3. Systemsettings
5.4. Pump pit settings
5.5. Pump 1 to 4 settings
5.6. Commonsettingsforpump1,2,3and4
5.7. SettingsforPIDcontroller
5.8. Settingsformixer
5.9. Drainpump
5.10. Cleaner
5.11. Analog logging
5.12. Settings for digital inputs
5.13. Settings for digital outputs
5.14. Settings for analog inputs
5.15. Settings for analog outputs
5.16. Settings for pulse channels
5.17. Settings for trend curves
5.18 . Communication settings
5.19. Settingsforeldbusmodules
5.20. Common settings
All settings require a pass code for SystemexceptsomesettingsunderthesubmenuSystem and the start/
stop levels under submenus Pump 1, Pump 2, Pump 3 and Pump 4,whichonlyrequireapasscodeforOpera-
tor.
Eachofthe21submenusaredescribedinseparatetables.Theexactprocedurehowthetablesshouldbe
interpretedisexempliedbelowforthesettingsunderthemenuitemSettings > System > System alarms >
Power fail in Table 5-1.
1. Choose the menu item Setting (or choose Main,selectSettingsbyusingtheUp/down buttons and press
Enter).
The topmost menu item System will be selected. Press Enter again.
2. Select the menu item System alarmsbyusingtheUp/downbuttons,pressEnter.
3. SelectthemenuitemPowerfail,pressEnter.
4. Select the menu item Alarm type,pressEnter and enter the pass code for System. Choose one of (Inactive,
B-Alarm, A-Alarm) and press Enter.
5. Select the menu item Alarm Delay,pressEnter and give the pass code for System. Set the number of
seconds and press Enter.
Thepasscodewillbevalidaslongasyoustayinthesettingmenus,forstep5above,youmaynotneedto
enter the pass code. How the buttons on the panel are used is described in Chapter 1 Overview.