Sulzer ABS PC 441 - Settings for PID Controller

81307063I
EN
64
5.7 Settings for PID controller
Table5-5showsthecompletelistofsettingsyoucanmakeunderthesubmenu PID Controller.
Table 5-5 Settings for PIDcontroller,under‘Settings>PIDController’
Submenu Submenu Setting Value Passcode Comment
Set Point
ExternalSetPoint
(O FF,
AnalogInput2,
AnalogInput3,
AnalogInput4,
Analog Input 5)
System
See Section 3.6.1
SetPointTracking (OFF,ON)
Startup Set Point
(LastSetPoint,
StartValue,Ex-
ternal Set Point)
Set Point Start Value m,ft
MaxSetPoint m,ft
Min Set Point m,ft
Output Signal
Start Up State
(LastState,Auto,
Manual,Blocked)
System
OutputwhenBlocked
(FreezeOutput,
BlockSignalValue)
BlockOutput Percent
MaxOutputSignal Percent
Min Output Signal Percent
MaxOutputChange Percent/Seconds
PIDParameters
ControllerDirection (Reverse,Direct)
System
P(Amplication) Number
I (Integration time) Seconds
D(Derivationtime) Seconds
OutputAtZeroDev. Percent
SpeedControlVFD
Min Pump Speed Percent
System
LockSpeed Percent
LockSpeedDelay Seconds
Reverse Speed Percent