Sulzer ABS PC 441 - Page 57

81307063I
EN
53
Submenu Submenu Setting Value Passcode Comment
SystemAlarms
Personal Alarm
AlarmType
(Inactive,
B-Alarm,A-Alarm)
System
AlarmDelay Seconds
MaxTimetoReset Minutes
Afterthistime,themaintenance
person must reset the timer
(bypushinganybutton),ora
Personal Alarm is sent out after
Alarm Delay
WrongPhaseOrder
AlarmType
(Inactive,
B-Alarm,A-Alarm)
Signals from main power monitor
CA443-0.
Limits here are the deviations
from the settings in the Main
power and the Main frequency
menu.
Limits also used as set points for
pumpblocking.
AlarmDelay Seconds
Over3~Voltage
AlarmType
(Inactive,
B-Alarm,A-Alarm)
AlarmDelay Seconds
Limit(+) Percentage
Hysteresis Percentage
Under3~Voltage
AlarmType
(Inactive,
B-Alarm,A-Alarm)
AlarmDelay Seconds
Limit (-) Percentage
Hysteresis Percentage
Unbalanced
3~Voltages
AlarmType
(Inactive,
B-Alarm,A-Alarm)
AlarmDelay Seconds
Limit(+/-) Percentage
Hysteresis Percentage
HighFrequency
AlarmType
(Inactive,
B-Alarm,A-Alarm)
AlarmDelay Seconds
Limit(+) Percentage
Hysteresis Percentage
LowFrequency
AlarmType
(Inactive,
B-Alarm,A-Alarm)
AlarmDelay Seconds
Limit (-) Percentage
Hysteresis Percentage
Set Password
Operator Integer Operator
For Operator access. The code
maybe1to4digitslong.The
factorydefaultcodeis1.
System Integer System
ForSystem(administrator)ac-
cess.Thecodemaybe1to4
digitslong.Thefactorydefault
code is 2.
Log and Alarm Reset
Analog Log
Cancel
System
Reset All
Alarm & Events
Cancel
Reset All