5-6
Tripod fixing screws
The TYPE-71C has screw holes for M8 screw and 1/4-20UNC screw. In a high
location, fix the splicer to a tripod to prevent it from dropping.
In a high location, fix the TYPE-71C to a tripod with the M8 screw or
1/4-20UNC screw on the bottom of the splicer to prevent the splicer from
dropping.
Caution
Screw hole for
M8 screw
Screw hole for
1/4-20UNC screw
The TYPE-71C is provided with Auto start function that automatically starts the splicing
process and the heating operation.
Auto start splicing
When the fiber is inserted into the splicer and the hood is closed, the splicing process
is automatically started. No need to press ( ) or to touch “start” ( ).
(See also page 4-11.)
Auto start
Auto start heating
When the fiber is placed into the heat shrink oven, the heating operation is
automatically started. No need to press ( ) or to touch “heat” ( ).
(See also page 4-11.)
Start
To Next Page
Loading...