6-5
*1 The applicable fiber protection sleeves vary depending on the cleave length.
60mm fiber protection sleeves ••••• Cleave length 5-16mm
40mm fiber protection sleeves ••••• Cleave length 5-10mm
*2 The protrusion part is not included.
*3 With Sumitomo identical fiber (in room temperature. Varies depending on the condition of fiber.)
*4 With the AC adapter in room temperature (20°C). If the battery pack is used, the heating time
varies depending on the temperature and the remaining battery capacity.
With Sumitomo protection sleeve FPS-40 or FPS-1. Coating diameter 250μm.
*5 With a new battery pack, 1 splice cycle time (splice + protection) completes in 90 seconds, in room
temperature. Splice & heat cycles may vary depending on the operating environment.
*6 Performed on the fiber stage after splicing.
*7 Non-condensing
*8
The Battery pack storage temperature range: -20°C ~ +50°C (if stored for less than 1 month),
-20°C ~ +40°C (if stored for less than 3 months), -20°C ~ +20°C (if stored for less than 1 year).
*9 Water resistance: Operates normally after being exposed to water dripping at 3mm/min, for at least
2.5 min on each of 4 surfaces tilted at 15°.
The test is held with the battery operation, carried out by
Sumitomo, but does not guarantee that the product is free of faults or damage.
Dust resistance: Operates normally after 8 hours in a dust chamber containing dust of particle size
75μm or below. The test is held with the battery operation, carried out by Sumitomo, but does not
guarantee that the product is free of faults or damage.
*10 The machine spliced the fiber successfully after dropped from 76cm height on 5 faces (excluding
top face) at free-fall. The test is held with the battery operation, carried out by Sumitomo, but does
not guarantee that the product is free of faults or damage.
*11 Electrode life is not guaranteed. This number may vary depending on the operating environment.
To Next Page
Loading...