S One User’s Manual
OPOS 3-12
The S One cutters can also read a barcode. Certain RIPs can print a barcode together with the
OPOS marks. This barcode can then be used to identify the job and automatically retrieve the
required cutting data from the computer.
A program must run on the computer that will act as a barcode server and monitor the
connection to the cutter. Once a barcode has been sent by the cutter, the program will search
for the corresponding file with the correct cutting data on a server (to which the RIP has written
the cutting file) and send this file to the cutter. Once the file is sent, the barcode server waits
again for a new barcode. This way, a complete roll can be cut without user intervention.
Depending on the program (barcode server), the procedure will either have to be started from
the cutter’s touchscreen or from within the program (Summa’s barcode server contains both
options). Please refer to the user's manual of the respective program to start the barcode
procedure from within the program. To start the procedure from the touchscreen, follow the
procedure described in chapter 3.3.4.2.
FIG 3-5
3-5 OPOS BARCODE JOB LOADED
To Next Page
Loading...
