S One User’s Manual
Specifications 6-2
• Four individually adjustable user configurations (e.g. for setting user-dependent
parameters like during length calibration) stored in non-volatile memory
• Autoload for automatic media pull from the roll
• Concatenation and curve smoothing to obtain better cut quality
• OptiCut drag-movement optimisation
• Overcut for easy weeding
• FlexCut for cutting through
• Panelling
• Vector Sorting
• Multiple recut feature (up to 999)
• Automatic cut sheet after a job
• Flash Eproms (upgrade over communication port)
• Print & cut alignment technology : OPOS 2.0, OPOS X, OPOS XY, OPOS XY2, OPOS
Extra
• GoSign
o Finishing software cut and print and cut jobs
o Material Database
o Windows 7, Windows 8 or Windows 10 (no home version)
o Action sets to automate the workflow
o Sorting facilities to shorten the output time
o Vector clean-up
• MacSign
TM
o Plug-in for Illustrator, for direct cutting to Summa roll cutter
o MacOS X (10.2 or higher)
o Connection by USB or TCP/IP
o OPOS support
o Registration required
• Summa Cutter Control
o Program to control cutter parameters
o Windows 7, 8 and 10
o Utility to upgrade the firmware
o Possibility to store user configurations on a hard disk
o OPOS Barcode Server
To Next Page
Loading...
