S 0ne User’s Manual
Detailed operation 4-5
This submenu allows you to enable or disable the internal segmentation function of the cutter.
Segmentation is used for several different applications. The most common are FlexCut and
long jobs with or without the roll-up option.
Paneling: to set panelling on or off.
Panel size: to set the panel size.
Panel replot: to set how often a segment should be recut. This function is interesting for
material that is thick and difficult to cut. The value of this parameter is ignored if segmentation
is disabled. If this parameter is set to 0, the cutter will cut each segment only once. If it is set
to 1, each segment will be cut twice.
Sorting vectors:
1.
Off:
Default value. The vectors are not optimized. Choose this option when the intelligence
of the cutter driver is preferred.
2.
Directional:
The vectors are optimized for the cutting direction (media movement). Choose
this option when the cutting pressure needs to be set relatively high (for example when
cutting through).
3.
Starting point:
Optimizes the starting point for closed curves. Choose this option when the
curves do not close as they should.
To Next Page
Loading...
