Summa S ONE - Procedure; Flexcut Principle

S One User’s Manual
Basic operation 2-11
The ‘cutting through’ functionality is focussed on cutting simple shapes (e.g. rectangles). It is
mostly used in combination with contour cutting. An interrupted cutting line (small ‘bridges’)
makes sure the material remains together. When the job is finished, the cut pieces can be torn
out.
FIG 2-6
2-6 FLEXCUT PRINCIPLE
Some cutting software can recognize the difference between a contour line and a cut-through
line. The software will send the data of the contour lines to the cutter first, activate FlexCut,
panelling mode and vector sorting and then send the cutting through data to the cutter.
Setting the parameters for cutting through the media:
NOTE: The following procedure describes how to set the parameters for FlexCut.
The values in the screenshots below are merely indicative. Refer to section
2.6.2.2 first for a description on how to get the exact parameters for the media
that you will be using.
1. Power on the cutter and load the media.
2. Tap .
3. Tap FlexCut .
4. Tap the parameter to set.
Cutting Length Flex Length
Full Pressure
Flex Pressure
Media
Cut
Not cut
S1D160
50000 x 145 mm
Knife
700 mm/s
90 g
Configuration 1
LAN 192.168.10.2
Knife pressure
Knife offset
FlexCut
Tool
Actions
Settings
Menu
Full pressure
Full pressure cut length
Flex pressure
Flex pressure cut length
FlexCut Velocity
FlexCut
2.6 Cutting through
2.6.1 Procedure