Need help?Do you have a question about the Summa S 75 and is the answer not in the manual?
Instructions for unpacking the cutter and assembling its stand.
Identification of front and rear components of the S CLASS cutter.
Details on connecting the cutter to power via mains and to a computer via USB/RS-232.
Procedures for positioning pinch rollers, setting pressure, and loading media.
Steps for installing knives, pens, and pouncing pins for different cutter heads.
Overview of the touch screen interface, its functions, and button symbols.
Guidance on setting tool type, pressure, and drag knife offset.
How to set cutting speed and change user configurations for different jobs.
Procedure for calibrating media length for precise cutting results.
Shortcuts for quick access to frequently used parameters on the touch screen.
Introduction to the Optical Positioning System (OPOS) for contour cutting.
General steps for contour cutting and calibration of OPOS system.
Creating graphics, printing, loading, and cutting contours with OPOS.
Automating multiple graphics cutting using OPOS for efficiency.
Overview of actions like Set Origin, Load, Reset, and Replot.
Detailed explanation of the configuration menu structure and options.
Parameters for optimizing cutting quality like Overcut, OptiCut, and FlexCut.
Settings for computer communication (RS232, USB) and detailed speed parameters.
Various tests and setup routines like calibration, sensor setup, and confidence tests.
Guide on cleaning drive system, media sensors, Y-guide rail, and nose piece.
Steps for safely replacing the fuse in the power entry module.
Technical specs for cutter models and media compatibility.
Specs for included tools, communication interfaces, and performance metrics.
Operating conditions and electrical requirements for the cutter.
Lists part numbers and pictures for S CLASS cutter accessories.
To Next Page
General