Summa S2 SERIES - User Manual

User’s Manual
Rev 6a

Summary

1 Setup

1.1 Unpacking the cutter

Instructions for safely removing the cutter from its packaging.

1.1.2 Setting up the stand

Instructions for assembling the cutter stand, including legs, panel, and casters.

1.1.3 Mounting the cutter on the stand

Steps for securely placing the cutter onto its assembled stand.

1.3 Safety, Ideal Operating Environment, Connecting to the Mains

1.3.1 Safety

Provides essential safety warnings and precautions for operating the cutter.

1.3.3 Connecting the cutter to the mains

Instructions for properly grounding and connecting the cutter to power.

1.4 Powering-on the cutter

1.5 Connecting the cutter to a computer

1.5.1 USB connection

Guide for establishing a connection via USB cable, including driver installation.

1.5.2 Ethernet connection

Instructions for connecting the cutter to a network via Ethernet.

1.6 Loading media

1.6.1 Pinch roller positioning

1.6.3 Loading media

Step-by-step guide for loading media rolls onto the cutter.

1.6.4 Media load procedure

Explains the minimal and full media loading procedures.

1.7 Tool Installation

1.7.1 Cutters with drag head

1.7.2 Cutters with tangential head

1.8 Activation of the barcode

2 Basic Operation

2.1 Touch Screen

Overview of the cutter's touch screen interface and its controls.

2.2 How to Set Tool Parameters

Guide on setting parameters for different tools like knives, pens, and pouncers.

2.3 How to set the cutting speed

2.4 How to make sure the sign has the correct size (Length Calibration)

Calibrating media length for accurate cutting, especially for multi-colored signs.

2.5 Cutting through

3 OPOS

3.2 Basic OPOS operation

3.3 Automating OPOS tasks

3.4 Calibrating OPOS

Procedures for calibrating the OPOS system and media for accurate contour cutting.

4 Detailed Operation

4.2 Action Menu

4.3 Configuration Menu

Accessing all user-dependent settings and configurations for the cutter.

5 Maintenance and Cleaning

5.1.1 Cleaning the drive system

5.1.2 Cleaning the media sensors

5.1.5 Cleaning the OPOS system

5.1.6 Changing the fuse

6.2 Specifications

6.2.1 Cutter

6.2.2 Media

6.2.3 Knife, pen and pouncing tool

6.2.4 Interface

6.2.6 Performance

6.2.8 Electrical

Summa S2 SERIES Specifications

General

Connectivity	USB, Ethernet
Media Types	paper, vinyl
Optical Positioning System	Yes
Power Requirements	100-240 VAC, 50/60 Hz
Software Compatibility	Adobe Illustrator, CorelDRAW
Dimensions	Varies by model
Weight	Varies by model
Repeatability	±0.004 inches