Summa S2 SERIES - 1.8 Activation of the barcode

S CLASS™ 2 cutter User’s Manual
Setup 1-37
Activation of the barcode
Before the first use, the barcode function needs to be activated. The activation happens
through our website (https://www.summa.com/support/product-registration/
). The serial
number of the cutter is needed for this activation. The serial number can be found on the serial
number label on the back of the cutter or in the system setup menu. It is recommended to get
the serial number directly from within the system setup menu.
Step one: obtaining the serial number:
Switch the cutter on
1. Press machine button
2. Write down serial number
and press back.
Step two activation of the barcode:
3. Go to the webpage and fill it out. The web page will show a 6 digit number which is the
activation code. A mail will be sent with the serial number and activation code. Please save
this mail for future reference.
4. Power on machine.
5. Press Actions
6. Press Unlock
OPOSbarcode
7. Set the value to the 6 digit
number from the website
and press Apply
8. Press Back.
Knife pressure 95 gr
Velocity 800 mm/s
Tool Tangential knife
Media size 50000 x 718 mm
Actions
Settings
Configuration 1
Pause
Origin
Eth. 192.68.1.7
S31211-10132
S2T120
Serial number: S31211-10132
Revision: 017
Build Jan 26 2016
Knife pressure 95 gr
Velocity 800 mm/s
Tool Tangential knife
Media size 50000 x 718 mm
Actions
Settings
Configuration 1
Pause
Origin
Summa USB port 1
Home
OPOS sheet
mode
Cut sheetCut off
Load Reset
Cut tests
Summa USB port 1
Unlock OPOS Barcode
Apply
0▌
Visit www.summa.eu/barcode
Cancel
S31211-10132
OPOS Barcode is unlocked