S CLASS™ 2 cutter User’s Manual
Setup 1-10
1.3.1.3 Warning labels on machine
The S Class 2
cutters use razor-
sharp knives.
Touching the knife with bare hands may cause
injury.
Hazardous moving part. Keep your fingers and
other body parts away from this area.
This label is located on the cutting head.
Fuse caution label. For continued protection
against risk of fire, replace the fuse only with one
of the same rating.
Double pole/Neutral fusing
This label is located near the power inlet, at the
rear.
Caution: Always leave the pinch rollers in the
upper positions when the cutter is not in use.
This label is located on the side of the scan axis.
1.3.1.4 Safety precautions
The S CLASS 2 cutters use razor-sharp knives. Touching the knife with
bare hands may cause injury. Do not touch the knives while the machine is cutting.
The cutter comes with a tool to insert the knives in the knife holder. Use this tool to prevent
injury. Put used blades in their original packaging for disposal.
The entire base plate should be considered as a dangerous area when the cutter is switched
on and off. The tool carriage can move from the left to the right and the yellow media sleeves
are sharp and can grab loose objects, clothing or body parts.
The cutter constantly measures the current through the motors. If the machine detects the
current is too high, then the current will be cut off to the motors and a fatal error message will
be displayed on the control panel.
Make sure to observe all the caution labels on the cutter.
WARNING: There is a risk of injury from being caught or trapped in moving
machine parts.
Keep hands, hair, clothing and jewelry away from moving parts.
Do not wear
jewelry, loose clothing, scarves, open jackets or shirtsleeves.
To Next Page
Loading...
