S CLASS™ 2 cutter User’s Manual
Detailed Operation 4-12
4.3.1.10 OPOS
The OPOS settings are explained in detail in section 3, except for scan speed and Monitor.
Scan Speed:
This parameter is a part of the G-Performance option. It is also only visible if the G-
Performance mode is activated. Setting this option to high speed enables faster reading of the
marks on wider substrates, provided the used material can handle the higher acceleration and
speeds.
Press the Scan speed button and set it to High speed or High quality.
Press to confirm or to cancel.
Monitor:
This option shows the read-out of the reflection of the OPOS sensor. The values can be used
to report a problem to a certified service technician.
To Next Page